This is a new version based on a very popular crochet bracelet I first wrote about in 2012. Please refer to the original post of December 16, 2012 for an alternate tutorial. A brand new Metallic Braided Nylon Cord is featured in this new tutorial with coordinated beads and buttons. However the crochet process is the same and it uses only chain stitch and single crochet stitch, so it is easy to learn.
Here are the materials you will need to make 2 bracelets:
- 1 Spool of Metallic Braided Nylon Cord - 0.9 mm in Ø - Gold, Silver or Copper - 6 m/6.5 yd
- 2 Buttons - Antique Silver, Brass or Copper
- Miyuki Duracoat Galvanized Seed Beads - Size 6 ~ 100 beads
- 1 Tapestry Needle Size 20
Or you can get a kit HERE with all the supplies listed above.
And why 2 bracelets? It is because each bracelet takes about 3 yard of cord. so there is enough on the spool for two bracelets...
Tools needed:
- 1 Crochet Hook - Amour Size 0, Clover Soft Touch 0, or Lacis 3
- Thread Burner or Zapper - Available Here
- 1 Bead Mat
1. With the thread burner, melt the end of the cord and make a pointed end, just like a needle.
2. Load about 50 beads.
3. If you already know which button you will be using, put to cord though the shank. If you are not sure which button you will use, you can wait to attach it until later.
4. Make a slip knot.
5. Insert the crochet hook into the slip knot.
6. Crochet 2 chain stitch. Slide 1 bead down. Crochet 1 chain stitch.
7. Turn the work around and make 1 single crochet stitch right into the first chain stitch. Slide a bead down and make a chain stitch.
8. Turn the work around. Make 1 single crochet stitch right into the previous bead (not the one you just added, but the one already in on the other side). Slide 1 bead and add a single crochet chain stitch.
Repeat this step until you get the bracelet length you want.
9. Tighten the button in. With the thread burner cut the cord leaving a 2mm tail.
10. With the thread burner melt the end and press it in with your finger or the thread burner cap. If you have never done this before, test this step first on a small piece of cord before proceeding on the bracelet.
11. Make the button loop with single chain stitches.
12. Cut the cord with the thread burner. Melt the end and press it flat in with your finger or the thread burner cap so it will fit into the tapestry needle Size 20. Stitch the loop back in. Cut the cord leaving a tail about 2-3mm long. Melt the tail and press it into the crochet. Doing this close to one of the bead will make the burn mark less noticeable.
The first bracelet is now ready to wear. Repeat these steps for the second bracelet and give the second one to your best friend or daughter... These bracelets are easy to wear and light weight. They can be stacked, worn in water, and washed when needed.
References
Turkish Flat Bead Crochet Bracelet with C-Lon Tex 400 Bead Cord - Go here to see this step by step tutorial
No comments:
Post a Comment